• Maximum resolution: 12,000 ppr
• Closed-loop vector control
• Price: Stepper motor < CM3+ < Servo motor

Q : Isn't the motor size increased by the integrated structure?

       Also, are there any disadvantages such as being more likely to be failed by the integrated structure?

A : Extra space is required for the L dimension +20.5 mm and the height +13.5 to 21.75 mm with respect to the motor size. However, since CM3+ can output a large

      torque with respect to the motor size, a smaller size of CM3+ can be used compared to a motor in general. Please click for the motor size.The risk of failure can

      be reduced by suppressing heat generation by the CM3+'s optimal current control agaist external load and protection functions.We have many experiences such

      as semiconductor devices with high duty ratio and medical equipment with strict failure risk management.

Since programs for motor are stored in microcomputer and commands are sent to a motor(s) every time, the development of microcomputer programs and the

processing capacity are required. 

Since programs can be stored in CM3+, CM3+ controls itself as programed only by applying a start signal. It is possible to significantly reduce the developing of

motor control for microcomputers.

Integrated microcomputer in the CM3+ lets you perform conditional branching processing and arithmetic processing according to the operating conditions and

external environment, and make a wider range of control development possible.

* CM3+ has 2 kinds of program, an operation sequence program such as positioning (Motion Bank) and a program that periodically executes conditional branch

processing and arithmetic processing (Logic Bank), and those two programs can be executed at the same time.

Since CM3+ has a built-in microcomputer, a controller may not be necessary in some cases.

The total cost of the equipment can be significantly reduced. 

CM3+ is equipped with various functions and parameter settings, and can be customized to fit in your application.

It is also possible to propose an optimal control for customer's application by using the microcomputer in CM3+.

Q : Is it possible to outsource the development of microcomputers?

A : Please contact us from the following as we will consult with you individually.